6.5TD Aluminized Crossover Pipe

Mandrel Bent 2.25" Crossover Pipe for all 6.5TD's in C/K trucks and Suburbans.

6.5TD Aluminized Crossover Pipe
Model: ssd-2230017	~~$139.99~~ $99.99
Shipping Overview: (Read More) United States and Canada - All Deliveries to the United States and Canada will be made by UPS. You will be quoted the shipping cost and presented with delivery options at the time of checkout. See our shipping calculator for more information. International Customers - Review Shipping Policies

Check Out

Mandrel bent 2 piece 2.25" (stock is 2.0") crossover pipe for all 6.5TD's in C/K trucks and Suburbans 92-00. Aluminized steel made in USA. 2 piece design to aid in installation. Being 2 piece, it means the flanges usually can be used over, if still in good shape. More flow means more hp and better mileage.

Hi-temp gaskets available as an option, see p/n ssd-734 in this category.

Stud kit and manifold flanges also available as an option, see p/n ssd-231 & ssd-3214 in this category.

1-clamp required, ssd-4722

Replace that leaky or damaged crossover pipe on your 6.5!

DANGER WARNING: SHOULD THE PURCHASER DECIDE TO INSTALL THIS, OR ANY OTHER EXHAUST PRODUCT AT HOME, BE WARNED THAT PLEASURE CAR OR LIGHT DUTY TRUCK/VAN "BUMPER JACKS" ARE INTENDED FOR EMERGENCY USE ONLY. THE USE OF FRAME CONTACT JACK STANDS IN CONJUNCTION WITH A FLOOR JACK AS MAIN SUPPORT IS HIGHLY RECOMMENDED TO MINIMIZE ACCIDENTAL DROPPING OF A VEHICLE WHILE THE INSTALLATION PROCEEDS.

Limitation of liability--Disclaimers: The regulation of emissions production, noise levels and safety standards is undertaken by the federal government, each of the fifty state legislatures, and by many local municipalities, towns and counties.
   The manufacturer makes no warranties of merchantability, of fitness for a particular purpose, or that its products are approved for general use, or that its products comply with laws, regulations or ordinances in the states where they may be sold to the ultimate purchaser, the consumer.
   The entire risk as to the conformity of this product in any such state and as to repair, should the product prove to be defective or non-conforming, is on the retail purchaser, the buyer, the ultimate consumer of such product and it is not upon the seller, distributor, or manufacturer.
   In this connection, retail purchaser, the buyer, the ultimate consumer assumes the burden of the entire cost of any and all necessary service, alterations, and or repair.
   The foregoing statement limits the liability of the manufacturer.